Torsion springs
The coil over your door has a gap in it
- Wire, ID & length measured
- American-made springs
- Door balanced by hand

Garage door torsion spring replacement is a measuring job before it is a wrenching job. The coil on the bar above your opening was chosen for one door's weight and height, and the new one has to match it. Our broader spring repair page covers extension springs too; this one is about torsion only.
Wolf technicians in Huntington Beach and around Orange County read the old spring before it comes off: wire thickness, inside diameter, overall length and which way it is wound. The springs we install are American-made. Once they're on, we put the right number of turns on each one, lock the set screws, and check the lift cables and drums that a snapped coil tends to knock loose.
Coil split above the door?
Leave the door down and call. Someone answers around the clock.
How a torsion job goes
Each step is done in the same order on every door we touch.
Read the old spring
Wire gauge, inner diameter, length and wind direction tell us exactly what to put back.
Let down the tension safely
The unbroken spring still holds energy. We unwind it with proper bars before anything is loosened.
Fit and wind the new coils
New springs slide onto the shaft, the winding cones get the correct turns, and the set screws are snugged to the bar.
Balance, then test
Lifted by hand, the door should stay put around waist height. After that we run the opener and its reverse.
Torsion setups we see
Single spring
One coil in the middle of the bar. Common on lighter single-car doors.
Two-spring system
A coil on each side of the center bracket. Heavier and double doors usually carry two, and they get replaced together.
High-cycle springs
Longer, heavier wire built for more open-and-close trips. A sensible pick when the household comes and goes through the garage all day.
When a torsion spring is done
Look up at the bar over the opening. These give it away:
- A visible split in the coilA broken torsion spring separates into two pieces with a clear space between them.
- The door feels like dead weightWith the opener released, a door you can barely lift has lost its spring help.
- One side lifts before the otherOn a two-spring door, uneven tension can tilt the door as it rises.
- Squeaks and stretched-out coilsCoils that have spread apart or grind as they turn are near the end of their cycles.
- Orange rust on the wireSalty coastal air speeds up corrosion, and a rusted coil is more likely to fail.
Safety first. Never loosen a set screw or put a bar into a winding cone yourself. A wound torsion spring stores enough force to spin the bar out of your hand and cause serious injury.
Why Wolf for torsion work
American-made springs
The coils we install are wound from American steel.
Every spring measured
Matched to your door's weight, not swapped by eye.
Answering 24/7
A snapped coil at midnight still gets a call back.
$25 off the job
Mention the coupon when you book.
