Licensed · Bonded · Insured · CSLB #1155503 Open 24/7Mon–Sun, 24/7Huntington Beach & all of Orange County
Wolf Garage Door Services logo
Spring Repair

American-made garage door springs, and why Wolf uses them

The pair in the photo is what Wolf puts above a door: two torsion springs, one red cone and one black cone, each end stamped Made in USA.

  • Wolf Garage Door Services team
  • Oct 11, 2026
  • 5 min read
Two garage door torsion springs, one with a red winding cone and one with a black cone, both stamped Made in USA

Ron posted the picture on the Wolf YouTube channel on October 11, 2026, under a line he has used before: built local, built to last. The caption says every spring Wolf installs starts as American steel and is wound by American Springs.

Below is what the post actually shows, what the panel under the photo claims, and what is worth asking before a spring is sized for your door.

What is in the photo

Two garage door torsion springs, one with a red winding cone and one with a black cone, both stamped Made in USA
The pair from Ron’s October 2026 post. Red cone on one spring, black cone on the other, Made in USA on the metal.

Two coils, side by side, still in the wrap they ship in. One winding cone is red. The other is black. Both cones carry a Made in USA stamp you can read without taking the spring out of the package.

That pairing is the ordinary setup on a two-spring door. One spring winds left, the other winds right, and they pull the shaft in opposite directions so the door stays level. A single spring, or two springs wound the same way, will not balance a standard two-car door.

Red cone, black cone

The color is a wind mark, not a coat of paint for the driveway. In the usual trade code, a red cone is a right-hand wind and a black cone is a left-hand wind. The pair in the photo is one of each.

ConeUsual meaningOn this pair
RedRight-hand windOne of the two springs
BlackLeft-hand windThe other spring
Stamp on the coneOrigin markMade in USA, readable on both

Wire size, inside diameter and length still have to match the door. Cone color only tells you the direction. A tech reads the old spring, or measures the door, before ordering the next pair. See spring repair for how that visit goes.

Where Wolf says the steel comes from

The panel under the photo is specific. It says the metal comes straight from Missouri, the springs are American-made, and they are wound by American Springs, which Ron calls a local manufacturer he trusts.

  • American steel. Not an imported coil that gets wound in the truck. The post is explicit about that.
  • Missouri. The panel says the metal comes straight from Missouri.
  • American Springs. Ron’s name for the shop that winds them.
  • Close to home. His line is that buying them here keeps jobs and dollars in the community, and that the spring is a choice, not just a part.

His reason for the weight, from the same caption: a garage door spring lifts hundreds of pounds every day, so he does not want a corner cut on the steel. That is the claim. It is not a lab report, and it is not a promise that every spring on the market fails sooner.

The parts warranty printed on the post

Under the springs, the graphic prints an up to 5-year parts warranty. The caption does not spell out which parts, what voids it, or whether a labor visit is included. Those details belong on the paperwork for the job, not guessed from a photo.

Estimates are free. If you are asking about springs, say whether the door is stuck and whether the car is inside.

What to ask before the springs go on

  1. Are both springs being replaced? On a two-spring door they were installed together and they have cycled together. Replacing one leaves a tired spring next to a new one.
  2. What are the wire size, inside diameter and length? Those three numbers are the spring. A close guess is how doors end up heavy on one side.
  3. Which way does each cone wind? You want one left and one right, the red-and-black pair in the photo, not two of the same hand.
  4. Is the stamp on the cone the one you were quoted? Made in USA is readable on this pair before the wrap comes off. If that matters to you, look at it when the tech opens the box.
Leave the shaft alone

A torsion spring stays wound while the door is shut. Loosening a set screw, or levering a cone with a screwdriver, is how people get hurt. If a spring has already snapped, keep clear of the shaft and call.

Need it fixed?

Garage Door Spring Repair across Huntington Beach and Orange County

A 5.0-star Google rating and a Huntington Beach team that answers 24/7.

Frequently asked questions

Are the springs in the photo made in the United States?

The cones are stamped Made in USA, and that stamp is visible in the photo. Wolf’s post says the steel is American, from Missouri, and that American Springs winds the coils. That is the sourcing Ron published with the picture.

Why are there two springs instead of one?

A lot of two-car doors are built for a pair, so the pull is even on both sides of the shaft. The photo is that pair: opposite winds, marked by the red cone and the black cone. Some narrower doors use a single spring. The door, not the box, decides which you need.

Does the 5-year line cover the whole visit?

The graphic says an up to 5-year parts warranty. It does not say labor is included, and it does not list exclusions. Ask which parts the five years covers before you approve the work.

Can I order the same springs online and put them on myself?

The cones and the wire size have to match the door, and the springs have to be wound with the right bars in the right order. Wolf’s post treats that as the technician’s job. If the door is already stuck, call for a spring repair instead of leaving a boxed pair on the porch.

Share this article Facebook X Email

Door stuck right now?

Call Wolf in Huntington Beach or Santa Ana. We answer 24 hours a day, every day.

Call now Free quote